This is a Kenwood VHF repeater, model number TKR This is a 32 ch, 50 watt repeater that operates in the Mhz range. Repeater is capable of both. Find great deals for Kenwood Tkr Repeater VHF 16ch MHz 50 Watts. Shop with confidence on eBay!. TKR) TCXO modules, % duty RF power amplifier output is 50W (at 50 % duty) a TKR is 40W (at. 50% duty). make Kenwood’s TKR/

Author: JoJozahn Mumi
Country: Cambodia
Language: English (Spanish)
Genre: Travel
Published (Last): 19 November 2006
Pages: 463
PDF File Size: 18.44 Mb
ePub File Size: 1.43 Mb
ISBN: 191-2-80101-458-7
Downloads: 26351
Price: Free* [*Free Regsitration Required]
Uploader: Barr

Modem bps, extra stability in high RF environments, includes interface cable. Includes one cable for radio connectivity. Price is very reasonable, and would buy one again. I built some 10 db pre amps and put them between the receiver input and the duplexers.

Otherwise it is a very nice machine. Item is an option and cannot be sold separately.

Kenwood TKR Product Reviews

I wouldn’t put a pre amp up near an antenna for love or money. Locking cabinet, providing 40 RU vertical mounting, solid front door, louvered rear door. They seem as reliable. When I was done programing the repeater I checked the rec and it was 1. Kenwood rates them at 25 watts continuous, and that seems accurate. Built in mini controller is nice. My Subscriptions Subscriptions Help. Kenwood makes a great repeater.


Kenwood TKR-750 / TKR – 850

I wound up using an Angle Linear GasFet preamp and a preselector to get it back up where it needed to be. We purchased the models, but the higher split should work fine in the ham bands. Software is very easy to use and a breeze to program.

We use these repeaters in commercial radio sites. New to Ham Radio? If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager. Includes equipment installation, hardware, cabling and wire management materials, and cushioned shipping crate. Clean, crisp audio otherwise.

Includes two cables for radio connectivity and an internal antenna relay. Standard aluminum equipment rack providing 17 RU vertical mounting.

Includes five pre-drilled openings and grommets. Audio is really good also. We’ve had the pre amps and TRK’s in service about 2 years with no issues. We have had the Kenwood TKR on the air for about 18 months and have not had any problems.

That takes about 5 minutes to do, but should be done for best sensitivity. Patent and other rights reserved. Cabinet Solid Floor Panel.

Kenwood TKR / TKR Repeater Base Units United Radio Communications Chicago

If anyone has a question on the programing on a kenwood tkr or let me know at kc9gmh15 yahoo. Crate for 42 inch 20RU Locking Cabinet. Cabinet Fan Top Assembly. Just asking for it to be blown out as I’ve seen time and time again. Then we bought 2 more to replace our aging Aerotrons. The rec goes down to.


Kenwood TKR-750K2

Do not use it. For use with voting systems, supplies Ohm balanced 2-wire audio, occupies 1 RU.

Email Subscription You are not subscribed to this review. I will agree that the sensitivity could be better.

Works great with my cat repeater controller,great audio also. I agree the comment about purchasing the Kenwood TKR instead of building a repeater from parts. Excellent performance, even with less than optimal filtration Kenwooe with W amplifier option. As for sensitivty I was disappointed.

Just want to let folks know that hams may be better off getting the low split K2 version, just FYI. Signal-to-Noise Modular Voting Comparator.

In the front part of the rec there are 5 tkr7-50 you have to tune with a signal gen. We have 7 of these repeaters on our linked repeater system, they have been operating flawlessly for 5 years or so. We had trouble with a out board controller and switched to the internal one without loss of service.